Monday, August 30, 2010

Converting Busway to Light Rail - the reality

Brisbane Tram
Every so often (often around election time), light rail, tram fanatics, and politicians come up with the idea of converting the busways to light rail operation. BrizCommuter has a look at the reality of this move.

In a Courier Mail article in August 2007, it was stated that the Cultural Centre stop handled 179 inbound buses per hour (bph) in the am peak, and the busiest part of the South East Busway handled 294bph. It can only be assumed that in 2010 even more buses are being run on the SE Busway. As far as BrizCommuter is aware, no light rail system can currently handle more than around 40 trains per hour (tph).  So assuming each of these 294 buses has a capacity of 65 passengers (which is an underestimate as many buses are higher capacity bendy-buses), then a light rail system running at 40tph would need trams that could carry at least 478 passengers just to match the current capacity of the busway. This would require a tram so long, that it would be the worlds longest tram at around 71m, and would also exceed the length of some busway stations such as Mater Hill. 

The cost of converting the busway to light rail would be considerable, and could take funds away from other public transport infrastructure projects such as fixing the under-utilised rail system. Even with the large expenditure, the busway would still be able to handle more passengers with buses than if it was converted to light rail.  This does not help the case for light rail conversion!

There have been suggestions of mixed mode operation, where buses and trams would share the same corridor. There are a few locations where this occurs, notably in Seattle. For starters the Downtown Seattle Transit Tunnel runs at a lower capacity than Brisbane's South East Busway. Mixed mode operation would decrease capacity at Cultural Centre, as trams being fixed to a track, cannot manoeuvre around another bus in a similar way that buses can easily manoeuvre around another bus. Anyone who has observed Cultural Centre bus station in operation can see the usefulness of the manoeuvrability of buses.  Seattle's system also has issues with bus wing mirror heights, that result in 16kph speed restrictions in the stations. Again, this would further decrease capacity.

Light rail conversion would allow for a very frequent service on the core busway route, but passengers travelling from locations away from the busway would have to change onto a feeder bus service. If this feeder service was no more frequent than the existing one seat journey into the city, then it would be considerably less attractive to passengers due to the additional change and resulting extra journey time. 

Given that the Eastern Busway will add even more buses onto the "almost congested" South East Busway, then future busway capacity is a major issue. The latest SEQIPP plan includes the "CBD Bus Infrastructure Capacity Program" between 2011 and 2020, although there seems to be little information of what this project entails. Certainly major changes at the Melbourne Street/Grey Street intersection will be required. Running more buses across the Captain Cook Bridge could be an option, maybe with bus lanes? A bridge paralleling the Victoria Bridge may well be required in the not too distant future to handle more public transport vehicles crossing the river. Whilst busway capacity enhancements are required, and light rail may help some of Brisbane's public transport problems, converting the existing busways to light rail is unlikely to be the answer.

5 comments:

  1. Hi Brizcommuter.

    Nice blog there!

    Ottawa's busway will be converted to LRT, in keeping with the philosophy that line haul PT should be conducted by rail.

    Unfortunately it seems our Busway will be difficult to convert, and if busway platforms have been built too short like you say, then that is very sad and disappointing news to hear as the busway was sold on the premise that it was Light Rail compatible and built to such standards.

    There are trams that can carry 510 passengers.
    There are light rail vehicles that can be coupled to form trains at 800 pax by linking four vehicles. Seattle's platforms are long enough to do this. It will take time to get patronage up as it only opened in 2009 if I recall correctly.

    Melbourne on St Kilda road runs ~ a tram a minute in peak hour. So that meets the 40 trams/hour mark. And this is on a road with no grade separation in place.

    Translink states that the busway carries around 12 000 pax in peak. 294 x 65 = 19,110 spaces, so 7000 spaces or so must be empty seats.

    I hope you don't mind if I link to your blog.

    BrisUrban
    brisurbane.wordpress.com

    ReplyDelete
  2. Adding light rail vehicles to form a longer high capacity vehicle is possible, but would require conversion of the busway to almost heavy rail infrastructure (Metro-Manila being an example of an LRT system that thinks it's heavy rail). Longer vehicles also equals lower frequency.

    By the way, Melbourne's St Kilda Rd is timetabled at exactly 40tph in the peaks.

    ReplyDelete
  3. That's odd. I have personally contacted Yarra trams and their scheduling department informs me that 58 trams are being run in the pm peak.

    Longer vehicles equals lower frequency but that said, it is more than sufficient to have a service coming every 7.5 minutes or 5 minutes.

    Future conversion of the busway is an issue that simply should have been dealt with at the design stage.

    Perhaps it should have been built as heavy rail from the outset.

    ReplyDelete
  4. 58 trams, or 58 trams per hour (per direction)?

    ReplyDelete
  5. The world's longest tram (Urbos 3 used in Budapest) has a capacity of 562 at a length of 59 metres. However I agree with your opinion that the money needed for tram conversion should rather be used for other, more urgent projects.

    ReplyDelete

All comments are reviewed before being published, and it may take a few days for comments to appear. If comments do not add to the conversation, or are just plain stupid, they will not be published.